Imported from the Apple Support Forums via the Wayback Machine 🔗
The lower slot in a B&W or an early G4 intended for a Zip drive. If you can get an internal floppy that has the same dimensions, there is no reason it would not fit. You might have trouble finding a faceplate, however.
0
Frank Van Sandt·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Thank you for your feedback.
But is the cable in the G3 and/or G4 suitable for a floppy drive?
Regards
Frank
0
Hussein (New York)·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Internal Floppy Drives use the same standard iDE/ATAPI connection as any optical drive or magnetic drive...
But why use such a low capacity unreliable storage device?
0
Forrest McElfresh1·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Conjecture and Rumor follow...........
G3 and G4 powermacs upto Quicksilver have solderpads on the mother board for an 20 pin connector that would seem to be an internal floppy interface. While the low level hardware to support a floppy seems to exist it is doubtful that a floppy driver was ever written to support it. This conjecture is based on the knowledge that these same pads were on the first iMacs and could be uses to support a floppy drive, but remember an iMac is not a PowerMac so while the modification worked on the one it may not work on the other.