Benches Vintage and obsolete

1

Power Mac 8100 Power Supply

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

Can anyone provide the power connector pinout specs for the 8100 motherboard? I need to re-wire a atandard ATX power supply to connect to the 8100 and aside from the +5v, +12v, -12v, and GND connections, I need to identify the function of the remaining three pins. No, I do not have a working power supply available to test from. From what I've been able to gather from online searching, the pin next to the +12v pin is the turn-on signal output to the PS, and the pin next to the last +5 wires is the +5v TRKL input. That leaves the pin next to the -12v pin, assuming the info on the other two pins is correct.

Many thanks for any assistance!

1 reply

Sign in or join Beachball Help to reply.

  1. 0

    KeithWicks

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I've just taken apart a Mac 8100, intending to use the PSU to power an external disk drive. The PSU has the following outputs:

    +5V 30A

    +5V (TRKL) 0.1A

    +12V 5A

    -12V 0.75A

    Maximum output power: 200W

    There is no switch on the PSU, both switch-on and switch-off being made by momentarily pressing SW1 on the motherboard.

    Wires between the power connectors on motherboard and PSU are coloured:

    01-04 Red +5V

    05-09 Black 0V

    10 (not connected)

    11 Blue -12V

    12 Yellow +5V Trickle

    13-16 Red +5V

    17-20 Black 0V

    21 White on/off

    22 Orange +12V

    The PSU also has wires with 4-pin connectors for disk drives, etc. Negative wires are black, +5V wires are red and +12V wires are orange.

    I do not have details of the on/off circuitry so, to be safe, I connected a 1KΩ resistor to pin 21. Touching the other end of this resistor to pin 12 (+5V trickle) started the PSU, and touching it to a 0V pin switched it off. This PSU appears to work correctly with no load connected.

    To use the PSU away from the motherboard, I shall permanently connect +5V to pin 21 via a 1KΩ resistor, and use a toggle switch for on/off.