Imported from the Apple Support Forums via the Wayback Machine 🔗
I have a G5 double processor and need to run my AVID Xpress software, which requires X10.3 to run.
i have bought an external firewire drive and installed x10.3 on a partition, but my G5 does not show it as a choice when I open system preferences and click on startup disk.
Anyone know what the problem is?
Thanks. This is kinda urgent, so any replies are greatly appreciated.
Imported from the Apple Support Forums via the Wayback Machine 🔗
With what machine did you use to install 10.3 from? If not the G5 dual processor, there is no guarantee it will work with the G5 dual processor. Macs will only boot off the operating system they shipped with and NEWER operating systems up to the limit of their hardware.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Thank you. So this is not possible, huh?
I used my G3 Powerbook to install the x10.3 on the external firewire hard drive.
Does this mean that I can use the software anymore unless I get a machine that can run 10.3?? AVID is not responding...
Thanks for your time.
Also, does this mean that in x10.5 time machine will not go back to a time before the 10.5 install? (I was thinking of upgrading)
Thanks for your time
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Searching Avid Xpress on http://www.versiontracker.com/macosx/ , I find that Xpress Pro is the only version of Xpress that has been updated since Tiger's release. It says it works with 10.4 PowerPC which means it should work on any G5 that could install 10.4.6 or 10.4.7:
As you'll notice a Leopard compatible release is planned.
Time Machine will recover any system that is stored in its recovery disc but you need a 10.5 installer disc to recover from it and a Mac that can install 10.5 (867 Mhz G4 or newer). If your G3 Powerbook has Firewire, it may be able to backup the Powerbook if it is mounted as a Target Disk Mode hard drive to another machine putting the Powerbook into Target Mode by booting it with the T key held down:
It can cure this sometimes, even can Bless a startup Partition if it got unblessed, yet won't help if the G5 can't run Panther.
Also, does this mean that in x10.5 time machine will not go back to a time before the 10.5 install? (I was thinking of upgrading)
Correct, in fact as it stands now, almost any backup APP is better than TM, ime.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
This is great, thank you. i will try to get around it.
To clarify: I only use my G3 for email at home. I used it for the install because the G5 would not run the x10.3 install disk that I purchased a while ago.
Unfortunately, my g5 didn't originally ship with x10.3, so I might be out of luck trying to get it to run on it... It came with x10.4 and I have upgraded my digital board and firmware since.
Thank you very much!
I think I'll hold off on 10.5 until I finish this job!
Cheers
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
This cannot be done. A newer computer cannot but up from a firewire drive that has an earlier OSX system.