Benches Uncategorized

2

Hard Drive operating temperature

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

Hi,

Recently I completed a upgrade-rebuild of a Sawtooth. It now has a Radeon 9800 with a Vantec exhausting VGA cooler, and a 1.8 Ghz CPU. Also there are 3 hard drives mounted on each of the three hard drive bays in the case. The two outer-mounted hard drives have attached hard drive coolers; the middle hard drive does not. Anyway, everything has been working just fine. I have been monitoring hard drive temperature, which hovered between 82°F(for fan cooled drives) and 89°F(drive w/o fan). I am unable to monitor GPU, or CPU temperature. Anyway, yesterday the system shut down while running iTunes, and the screen went completely blank. The case did not feel hot to the touch, and there were no burning smells. So, I immediately rebooted the system, all the fans came on, but the monitor screen was blank. I shut her down, and opened the case to ensure all wiring was connected. I also gave the GPU, and CPU a gentle touch to see if they were hot; but they were just warm. I rebooted again, and the system booted fine, and has been running since. The hard drive temperatures have elevated to 87°F for the cooled drives, and 96°F for the fanless drive. I'm not sure why the hard drive temperatures rose? It did get a little hot and humid here yesterday, but only in the low 80's.

Sorry to be so verbose. What is the optimal operating temperature for a hard drive? What about temps for a CPU, or GPU; and how can I monitor their temperatures?

Thanks,

medinaray

2 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Hi-

    Hard drive temps up to 50ºC (122ºF) are within limits.
    87º-96ºF are not a problem for the drives.

    GPU temps can only be monitored with a probe between the heatsink and the processor chip.
    I would expect up to 70ºC (158ºF) load temps.

    7447A temps shouldn't get much past 60ºC (140ºF). After that, there may be stability problems.

    Are you running the stock PSU?
    If so, you are probably pushing the PSU too hard with 3 drives, a processor upgrade, the 9800 and the fans.
    I found that the PSU was overheating, one, due to all the extra hot air, and two, the extra loads on the 12v rail.
    If your case fan is blowing in, turn it around to blow out.
    The case leaks enough that it won't starve, and the heat going out the side should help the PSU.

    What you describe is exactly why I changed my Sawtooth's PSU to a 520W ATX, and added a blowhole fan to the top of the tower.
    Once that was done, the machine ran even faster than before (with the OEM), ran cooler, and was rock solid.

    The OEM PSU can run an upgrade CPU and a graphics card, but only 1 hard drive.
    After that, the heat and power demands of the extra drives plus the graphics card and the processor get to be too much.

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Hi,

    and thanks Japamac.

    I installed a 550W front and rear fan PSU. Reconfigured of course.

    But, I now believe the problem is a CPU voltage issue that you have been reading about in the Giga Designs Voltage post. Hopefully this will clear up soon.

    medinaray