Imported from the Apple Support Forums via the Wayback Machine 🔗
Hello,
I'm converting an ATX PSU for use on a Sawtooth. The PSU I have is 20 + 4 pin type. So the 4 pin part is discarded on a Sawtooth. Anyway, my question is: can I use the 3v(Orange) line from the discarded 4 pin part, and move it over to pin 8, instead of soldering a nearby 3v line onto the pin 8 line? I'm thinking I can just remove the 3v. orange line from the discarded 4 pin part, install a new pin, and insert it into the pin 8 slot on the motherboard connector.
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi-
It doesn't matter how, just as long as you get +3.3v to pin 8. You still need to abandon the -5v on pin 18 and make it GND. Again, whatever method gets the job done.
And make sure all pins are of the proper voltage before plugging the PSU into the logic board
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
OK, thanks.
medinaray
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗