Benches Uncategorized

2

ATX conversion question

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

Hi,

I'm converting an ATX PSU to work on a Sawtooth.

One of the pins that needs conversion is the -5 volt ATX pin(white wire pin #18) to ground for the Sawtooth. However, the ATX unit I have does not have a -5 volt pin. The slot on the connector where pin #18 would live is vacant. My question is, should I supply a ground wire there, or leave it vacant for the Sawtooth?

Appreciate it, thanks

medinaray

2 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I followed the diagram here. the -5v is discarded. I unsoldered mine from the PSU board.

    http://atxg4.com/sawtooth.html

    Message was edited by: kmac1036

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Thank you kmac. I'll discard the -5.

    Have a good one.

    medinaray