Imported from the Apple Support Forums via the Wayback Machine 🔗
I use this particular Mac as a workstation for Logic Pro. I have two USB cables connected to the computer. One is for a powered hub (hosting a midi interface and an iLok key) and the second is for an audio interface. These devices are plugged into a power strip. Before I finish a session, I turn off the power strip to which these devices are connected. I then get the following error message on the Mac:
"Because a USB device was drawing too much power from your computer, one or more of your USB devices have been disabled. To prevent damaging your computer, the USB device drawing too much power has been disabled. Other devices may have also been disabled. When you disconnect the device drawing too much power, your other USG devices will be enabled again."
Is this a problem? Am I doing the computer any harm? I'd rather not be reaching around the back of the iMac to unplug the USB cables every time I turn off the power strip if I don't have to.
Imported from the Apple Support Forums via the Wayback Machine 🔗
The computer is actually trying to protect itself from an overload on the USB and is giving you that error as the devices try and draw the required power. I would be a little concerned about that.
Can you simply add another powered hub to give you access to USB ports that aren't behind the machine?
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hey DaddyPaycheck,
Thanks for the reply. Here's what I do, in order.
1. Quit Logic. 2. Disconnect external hard drives. 3. Turn off power strip to which the powered USB hub is connected. This is when I get the error message.
So after I cut the power to the USB hub, is it the trying to draw power from the computer? I'm not sure where else I can connect the hub. The computer has a wireless keyboard, so no USB port there. And I could always disconnect by pulling the plug on the back of the machine (though being an iMac, it's a pain to get reconnected as everything is in the back and virtually invisible). My other option is to just leave the power strip on and say screw it.
Jim
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Yes, it sounds like the hub is still trying to draw power from the bus. Maybe you could put the hub on a different power source so that you can still shut everything else down.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Good point. I'm in search of an extension cord as I type. Thanks.