Benches Uncategorized

5

DVD Studio capabilities

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

I'm new to working with video on the Mac and have some question about DVD Studio. It appears that I can create DVDs longer than 2 hours by adjusting the bit rate -- is this correct? Recognizing it is a subjective question, how low can the bit rate go before it is unwatchable? Finally, is DVD Studio only available as part of Final Cut Studio? Thanks.

5 replies

Sign in or join Beachball Help to reply.

  1. 0

    RedTruck

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    The bit rate is indirectly proportionate to the quality of the footage. Meaning, if you have motion in the shot, the bit rate will affect the quality depending on the amount of pixel change there is frame to frame. If you had a still shot, with no movement, the bit rate could be as low as the DVD standard will allow, because it only has to render the frame once, and that will persist. Video compression has everything to do with the pixels on the screen, not the length of the video.

    That being said, taking all things into account, you set your bit rate depending on the movement in the frame compared to the length of the video, knowing that you can't have a total bit rate higher than 10.08 Mb/s. If your video is less than an hour, you can max out your vid bit rate. If it's longer than 2 hours, you'll have to decide what is more important: having the entire movie on a single DVD, or having it playback at a higher quality.

    SHort answer, you could go as low as 2 Mb/s in Compressor which will get you close to 3 hours on a DVD, but if you so much as turn your head it will be very ugly. You might get by with just blinking.

  2. 0

    Shawn Birmingham

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    First you have to realize that not all MPEG-2 encoders are created equal. Compressor does a good job, but there are others, like BitVice, that will do a better job at lower bitrates.

    2 hours is all you want to put on a single layer DVD. More than that, and even with a great MPEG-2 encoder, you will have a noticeable loss in quality.

    DVD SP is now only available as part of Final Cut Studio.

  3. 0

    SteveHP

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Thanks for the quick response. I left out one (somewhat important) piece of information. I'm working on producing DVD recordings of school board meetings which are rarely shorter than 2 hours. We had been recording directly to a DVD burner which gave us as much as 6 hours at a reduced quality. Now we want to do some editing, adding titles, etc. If I encode a 4 hour meeting at 2.3Mbps in DVD Studio, will it look appreciably worse than if I burned to directly to a DVD at the 6 hour capacity setting?

  4. 0

    PDTV is back

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I seriously doubt that encoding at a custom bitrate tailored to the length of the meetings will be lower quality than the fixed "6-hour" setting of a set-top DVD burner. You should notice either a slight increase in quality, or no change at all. I imagine there's not a lot of fast motion in school board meetings (unless somebody sneezes), so you should be fine at whatever bitrate you need to fit a single meeting onto a DVD-R.

  5. 0

    SteveHP

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Thanks for all the quick responses