Imported from the Apple Support Forums via the Wayback Machine 🔗
I am using OSX 10.2.8 with a wireless D-Link adaptor in the USB port on a G3 Powerbook. My wireless network has a 10 digit hex wep key. I know that on Apple, you have to use a $ in front of the key to make it work, though I admit I dont understand why this is necessary. In any case. My wireless adaptor set up will not accept a $ in the hex field and even if it would, it limits the characters to 10 for a 40 bit hex wep key. How can I get the $ in front of the 10 digit key??? Without the $ in front of the wep key, the router sees it as not a valid key. Thanks for your help.
Imported from the Apple Support Forums via the Wayback Machine 🔗
berrypicker,
I have no advice but someone may come along that is helpful. If not, I would post on the Tiger's Getting on Line forum since earlier OSes don't have much traffic. This should be a generic networking problem independent of the version of OSX.
Imported from the Apple Support Forums via the Wayback Machine 🔗
OK I will try that. Thanks for your response.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
$ in front of a WEP Key? Really? Wow, I've had a G3 Lombard Powerbook for a few years. first I was using it with a Linksys WEP54G wireless G access point,using a 10 digit WEP Hex key, and now I have replaced that with a D-Link DIR-628 Wireless n Extended Range Dual Band Router using WPA2. I have never inserted a $ in front of the key in the past, and do not now, and have never had a problem. I have never heard of this before.