Imported from the Apple Support Forums via the Wayback Machine 🔗
I have been trying to print a special size design (5"x5") and although the Preview in the print dialogue shows everything to be fine - the outcome is that there is about a 1/4 inch border around the final product. Since one of the elements in the design goes to the edge - it is cutting off part of the image. I have tried adjusting all of the margins and almost everything else. It is still doing it. Any suggestions would be most helpful. Thanks - Carlyle
Imported from the Apple Support Forums via the Wayback Machine 🔗
Is your printer capable of printing to the edges of the page? Most consumer grade printers are not.
Either reduce the size of your image slightly, or print to larger media. In either case, trim the borders as necessary after printing.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Thanks. What is strange is that if I choose the Borderless setting it does print to the edge. Unfortunately it also blows up the image and then it doesn't fit. However the image gets printed to the edge of the paper. So it is strange.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Not strange at all. The image has to be enlarged so that it extends beyond the edge of the paper so that there is not a small unprinted strip at the edge. You will have to resize your layout accordingly. Incidentally, there should be an adjustment somewhere in the print menus to set just how much the image is expanded. You’ll have to use trial and error to determine what works best in this particular case. Usually it’s best to set it for the maximum amount, but you may be able to get away with less.
Walt
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Carlyle,
When you created the custom page size did you set the margins as zero?
This has nothing to do with your layout, it is all set in *Print Setup…*