Sawtooth Mods
Imported from the Apple Support Forums via the Wayback Machine 🔗
Well, this report is a long time coming, but I'm happy to finally be giving it.
Many months ago I decided to install a ATI Radeon 9800 into my Sawtooth, but realized I would need a PSU boost to do so. The Sawtooth comes with a 237 watt PSU which is not sufficient enough to meet the 300 watt minimum required for the 9800. I decided to get a 500 watt unit, and began to search for one. After much research I chose an Antec [Neopower 550|http://www.antec.com/usa/productDetails.php?lan=us&id=28550]. This is an outstanding PSU for a decent price. It is modular, so you plug in only the cables you need....this means minimal cable clutter (and in the tight confines of the Sawtooth's case minimal clutter is critical, especially where heat is concerned). The fan on this unit is sensored, and variable in speed. It is also mounted in the same place as the fan on the Sawtooth's original 237 watt PSU. Finally, the Antec fan is very quiet, except when heat builds up it cranks up a few gears and is a little louder until the heat dissipates, then it slows.
The Antec 550 is an ATX PSU, so the power supply connector must be rewired in order to make it compatible with the Sawtooth. This is a simple, and easy job, diagrammed [here|http://www.xlr8yourmac.com/systems/ATXG4_AGP_conversion/G4_AGP_to_ATX_casepg2.htm#next]. The power connector on the PSU is plenty long, so you can rewire it if you want. I opted to rewire a 20 pin extension so that the PSU's connector would remain intact.
Now that I had the power I could install the Radeon 9800. I purchased a flashed 9800 on Ebay pretty cheap (cheaper than a made for Mac 9800). I replaced the weaker OEM fan on the 9800 with [this stronger one|http://www.vantecusa.com/front/product/view_detail/95]. [This article|http://www.xlr8yourmac.com/Graphics/VGAsilencer_install/VGA_silencerinstall.html] explains how to disassemble the OEM fan, and install a new one. This process includes cleaning the old thermal compound off the 9800 GPU, and reapplying compound to the GPU for the new fan. I was hesitant to apply thermal compound to a critical component like a GPU, but based on advice from Japamac, I bought some [Arctic Cooling MX-2 compound|http://www.arctic-cooling.com/further_prod2.php?idx=140] applied it to the 9800 GPU, and installed the Vantec fan. MX-2 requires no curing, so I immediatley installed the 9800 and fired up the Sawtooth. So far, so good....all mods are working fine. It's wonderful to have the open GL capabilities of the 9800....The graphics are a huge improvement over the ATI Rage 128 card I replaced.
The last modification I performed was to replace the original 120 mm fan with a [Scythe Slipstream 120 mm, 1900 rpm fan|http://www.scythe-usa.com/product/acc/026/sy1225sl_detail.html]. At 1900 rpms the Scythe is still quieter than the original, and a much better cooling unit.
Well, there you have it. Have a good one.
0 replies
Sign in or join Beachball Help to reply.