Benches Uncategorized

3

My headphone jack and speaker jack aren't worki...

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

This has been posted in the Logic Pro section too....

Hi everyone. Is it possible to damage just the left (or right) channel on the stereo out? I still don't have an audio interface yet, so I've been using the stock headphone jack for my headphones, and the stock speaker out for my Creature Speakers. They are both quieter on the left side. I think this has been happening for a couple of months, I just thought I was losing my hearing a bit on the left side, especially with headphones on. Turns out I'm OK, it's the stereo outs that aren't working right.

I found out that it's not me when I plugged in my active monitors, KRK Rokit 8s, and tried both speakers in iTunes, Garageband and Logic Pro. I played with the panning in both GB and LP, but the speakers on the left weren't as physically active/vibrating as much as the right. I did switch the inputs on the KRKs to make sure it was the channel and not the speakers.

The left channel isn't gone mind you, it just sounds quieter, more muffled with less high end. Maybe even a little distorted. I didn't want to turn it up to high to see if I could hear distortion clearly just in case.

I'm really really hoping that this isn't a hardware issue (I know that there's a 95% chance it is). I'm really hoping that there is a small preference or utility app that can control the panning of the systems output and I just don't know about it. I'm still holding out hope for that.

But if there's no hope and it is a hardware issue, any suggestions on what I should do?

Thanks for your time and sorry for the long thread. I look forward to hearing from all you geniuses.
X

3 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Run Audio MIDI Setup (Utilities folder), set "Properties For" to the audio output device, and make sure both Audio Output volume sliders are the same distance to the right. Of course, check the "Balance slider ' the "Output" tab of "Sound" system preference.

    If the hardware is bad, the cheapest fix is to get the iMic
    <http://www.griffintechnology.com/products/imic/&gt;

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    If it was the jack on the front/back of the tower, only one output would be affected. If you have anything that you can hook to the optical out, and monitor that, (I have an old minidisk recorder around somewhere,) that will tell you if the Digital to analog conversion is the problem. If digital out suffers the same problem, check any oddball software like audio hijack (Pro)

  3. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Malcolm,

    Thank you so much for your help. It turns out that the left channel was turned down to almost half in the Audio MIDI Setup utility. That is a HUGE load off my mind.

    The weird thing is I haven't used AMS since I set up my computer almost two years or so ago. I know I didn't turn it down. Hmmm....

    Any thoughts in closing?

    Timotheus,

    Thank you for the suggestion. Fortunately, I didn't need it, but that doesn't make your information any less useful. I learned from your post as much as I did from Malcolm's, so thank you too.

    Best,
    X