Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi all,
I have an 2 x 3GHz Quad Core MacPro running OS X 10.4.11.
When i boot up my machine I get an error:
'USB OVER CURRENT NOTICE, A USB device is currently drawing to much power. The hub that it is attached to will be deactivated.'
After pressing 'OK'. The system seems to work fine after, but i'm just a little worried about this message cause it pops everytime the machine is turned on. The only devices that I have connected to the machine is the apple mouse and keyboard. I have connected them to different ports, but with the same results.
Imported from the Apple Support Forums via the Wayback Machine 🔗
That is the message you normally get when a USB device is plugged into the Keyboard that draws too much amperage.
If you have nothing other than say a Mouse plugged in there, then maybe you have a defective USB device.
Do you have any like USB drives that don't have their own Power Supply?
A USB2 Hub will generally solve this.
See if you get the message with out anything plugged in to USB. Try just KB & Mouse one at a time while booting.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
This error should not occur with just a keyboard and mouse connected. Put your OS X Installer Disc One into the optical drive then restart the computer. After the chime press and hold down the "D" key until the diagnostic screen appears. Run the extended diagnostics. If any errors are reported note down the error code(s) received.
Note, too, that the keyboard should be connected only to the USB port designated on the rear of the computer.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi Kappy, i have tried as you suggested. i completed the extended diagnostics and no errors where flagged. but upon reboot i still get the same error message.
i will give the computer a complete reinstall and see if that makes a difference.
thanks for your help
O
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
I am on a MacBook Pro and I get the same message. I don't have any device connect to the laptop. Let me know if you figure it out and I will do the same.
wcf
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
a little up date.
i have given my macpro a complete reinstall and i'm still getting the same message. i have been on the phone to apple and all could tell me was to zap the pram and reset the smc and neither worked.
looking around on the internet this seems to be quite a common problem
any ideas or suggestions would be appreciated
thanks
O
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Have you tried a different keyboard and mouse? They don't have to be from Apple, as long as they use USB.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
As I said that should not happen. I believe you have a computer with some sort of defect on the motherboard. If it's still in warranty then I would arrange to have it diagnosed and repaired.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi Malcolm, i did try different keyboards and mice, but with the same results.
i have now dropped my macpro off at the apple store for repair. apparently it was a problem with the logic board, i had a older version motherboard on my macpro.