Imported from the Apple Support Forums via the Wayback Machine 🔗
Ok running OSX 10.6.1 on a MacBook, AEBS with firmware 7.4.1 Airport Utility 5.4.2
I've set up the printer and both the AEBS recognizes the printer and so does the Mac and I can add it through the normal manner in the Fax/Printer pref pane.
But when I try to print a test page I get an error that the response was bad "too short"? I've tried adding it manually and still no go.
Has anyone else had any luck adding the F4280 with a similiar config as mine?
Imported from the Apple Support Forums via the Wayback Machine 🔗
Sometimes the "Reset Printing System" trick will straighten things out. See attached link.
But, it would also be a good idea to first work your way through the troubleshooting guide step by step first. Apple recommends the "reset" as basically a last resort.
Imported from the Apple Support Forums via the Wayback Machine 🔗
Thanks, I've tried everything right up to the reset printing system. I'll give that a go tonight and see how it works.
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Well just tried everything you suggested and I still get the following error when I try to initially print.
"Unable to read response header - short read"
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Ok so I updated the AEBS to 7.4.2 and now printing works like a charm. Only drawback is that my Drobo disconnects randomly and causes my whole system to hang.