Benches Peripherals and accessories

5

22" LCD flickers when using cloned ext FW HDD a...

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

This happens after display awakens from sleep only. Using FW external hard drive as boot volumes makes 22" LCD flicker. Would the graphics card cause this? or is it something to address within system preferences or perhaps display pref's?

Image Hosted by ImageShack.us

click here

Any help would be sincerely appreciated.

5 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Off hand it sounds like a voltage problem, is this external a LaCie HD, or a Bus powered drive?

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Bytecc 5.25" enclosure w/ quad inputs (FW800/400/eSata/USB2) and internal 7200 sata HDD

    click here

    if I set the display to never sleep then I have no flickering issues. I guess I could have my screen saver pop up a bit sooner than normal. I'll give it a try and post back with results.

    Message was edited by: SDMacuser

  3. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Hmmm, is it this one using the original FW cable perhaps?

    Pros: Seems to work when you hook it up with a good cable. Looks decent with a black drive inserted. Solid aluminum enclosure is nice.

    Cons: Firewire cable included is defective. One end of the connector is too short. So you can't plug it in all the way. You'll need your own firewire cable. Also the internal cooling fan starts to buzz sometimes.

    Other Thoughts: It seemed like a high quality enclosure at first, until I actually tried to use it. I would not buy another one of these.

    http://www.newegg.com/Product/Product.aspx?Item=N82E16817145064

  4. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    The device itself is ok but the included Bytecc cables are terrible (especially the included FW800 cable). I use my own /shielded fw cables instead (tested on other devices and work perfectly). I completely agree with the above quote in that I'm not likely to buy any more of these enclosures (at least not from this manufacturer).

    I purchased it because these 4 input enclosures are rare if not difficult to locate at a reasonable price .... someday I plan to add a Blu-ray burner and I needed a 5.25 inch enclosure for the burner.

    -------------------------
    Update: It appears that setting all energy saving controls to Never helps. I also have the screen saver take over sooner to keep the LCD in good shape. No flickering yet and I hope it stays this way.

    Message was edited by: SDMacuser

  5. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    It seems that powering on and off twice in a row resolves this issue. No way to prove it's voltage related short of using an alternate outlet which didn't help either.