Benches Networking

15

PS3 DNS Error using Airport Extreme

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

I have an Airport Extreme and I am getting a DNS error when I try to setup a connection to my Playstation 3. I have found the DNS number on my network settings on my iMac, but that does not seem to work. I used the DNS numbers that I found on my Airport utility and that did not work. I have seen some posts saying to use Terminal to turn off Internet Sharing, but that has not worked. The PS3 finds my IP address, but I always fail out with the DNS error. Any help is greatly appreciated. The cable company was no help as well as they say the DNS number changes.

Message was edited by: PetFed311

Message was edited by: PetFed311

15 replies

Sign in or join Beachball Help to reply.

  1. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Hello PetFed311. Welcome to the Apple Discussions!

    Do you have the 802.11n (squarish) or 802.11g (dome-shaped) AirPort Extreme Base Station? Regardless, is the Extreme the only router in your network? That is, is it directly connected to your Internet modem? Finally, what is the make/model of that modem?

    The cable company was no help as well as they say the DNS number changes.

    I'm not sure why they would tell you that, as this number rarely changes. Most ISPs use the same DNS servers throughout the length of your service with them. Only the Public IP address will tend to change, unless you have been provided a Public static IP address from them.

  2. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I have a 802.11g (dome-shaped) Airport extreme and it is connected to my cable box. I had previously just hard wired the internet to my iMac, but got the Airport extreme from my brother so I could have the PS3 online too. The internet is working fine on my computer using the Airport extreme. I am not at home currently, but I will post the cable modem type later.

    Message was edited by: PetFed311

  3. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Ok, thanks for clarifying your network configuration. I assume that you have your iMac connected directly to the 802.11g AirPort Extreme Base Station (AEBS) by Ethernet and you want to connect the PS3 wirelessly ... correct?

    If so, then we need to double-check the settings for all three devices. Think of DNS as the Internet's version of the Yellow Pages. Without the correct DNS information, a network client will have difficulty locating things on the Internet. Typically, your ISP provides you with the DNS server information using DHCP. In this case your AEBS would need to be configured to be a DHCP client in order to receive this DNS information. In turn, the AEBS also is a DHCP server and will provide this to any network clients (wired or wireless) connected to it. In order for that to work, both your iMac & the PS3 would need to be configured as DHCP clients. Make sense so far?

    Since your iMac is getting Internet access, it (most likely) is getting the proper information from the AEBS. I suggest that you note the IP settings on the iMac; you will want to compare these to what the PS3 is getting.

    To review the IP settings on your iMac, you will use System Preferences. In order to give you the proper steps to do so, I will need to know what version of OS X you are running on it?

  4. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I am running Mac OS X v. 10.5.8

    Currently I am running the iMac internet off the router as well. Would it be better for the PS3 setup if it was hard wired?

    My cable modem is a Motorola SB5101 SURFBOARD cable modem.

  5. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Currently I am running the iMac internet off the router as well. Would it be better for the PS3 setup if it was hard wired?

    I assume that you mean that the iMac is wired to the AEBS ... correct? Did you check the IP settings (IP address, Subnet Mask, Router IP, & DNS IP addresses) using System Preferences for your iMac? If so, the PS3 should have the same values, except the IP address (which would be in the same range as the one the iMac has ... are they?

  6. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I have tried to put that same numbers into the PS3 (with the different IP address) and the DNS error appeared.

    The iMac is wired to the AEBS, but I can do either hard wired through the AEBS or use it wireless with my iMac.

  7. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I suggest that you (temporarily) connect the PS3, by Ethernet, to the AEBS. Before doing so, be sure to power-down all of your equipment. After connecting the PS3, power-up the equipment in the following sequence:

    o Power-up the modem; wait at least 10-15 minutes.

    o Power-up the AEBS; wait at least 5-10 minutes.

    o Power-up the PS3.

    Using the PS3 administration capability, verify that the PS3 is set to be a DHCP client and that it is getting the proper IP information from the AEBS ... is it?

  8. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    It asked me for a DHCP host name in the setup. I do not see anything about a DHCP client when I am in the PS3 network connection setup. It never picks up the IP address information automatically or correctly. I always type it in.

    And what do you mean by PS3 administration capability- is that the network connection settings?

    Message was edited by: PetFed311

    Message was edited by: PetFed311

  9. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I will be referencing the
    Sony PS3 Knowledge Center support site to help us both go through the steps to configure your PS3 for Internet access.

    I would like to start with the steps to connect your PS3, wirelessly, to the AEBS.

    o Skim down the page until you see the list of tabs under the heading: Configure network settings.

    o Choose the tab, titled: "How to connect online (Easy)."

    o Select the Wireless option.

    o Click the FWD button to advance to the Internet Connection page and verify that it is enabled on your PS3.

    o Click the FWD button to advance to the page to select either Easy or Custom. Choose Easy.

    o Click the FWD button to advance to the page where the PS3 will scan for your wireless network. Can it find yours? The default AirPort Network Name (or SSID) is: Apple Network xxxxxx, where the x's are the first six digits of the base station's AirPort ID.

    o If your PS3 cannot find your wireless network, you may need to use the "Enter manually" option instead.

    Please post back your results.

  10. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    These are instructions that I have been doing for 2 days now. That PS3 site is very basic instructions for connections with no problems,

    My topic is concerning a specific problem that I have found affects many people. It is a DNS error 80710102. I succeed with my IP address, but it fails with the internet connections and gives the explanation of DNS error 80710102.

    There are many topics online saying that the airport extreme has issues with the PS3 and this DNS error.

    I have tried Open DNS, using my IP address as the DNS, using 4.2.2.2 & 4.2.2.3. I feel like I am trying all the tricks of the online trade, but still the DNS error 80710102.

    I dont know if some setting of my router.

    What did you mean when you said a DHCP connection. I have not tried that bc I dont know I had one and dont know the name.

    Message was edited by: PetFed311

  11. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Message was edited by: PetFed311

    Message was edited by: PetFed311

  12. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I apologize, but if you had provided the details of what you have already tried to do to troubleshoot, I wouldn't had taken you down this bunny trail ... and for that, I am sorry.

  13. 0

    Tesserax

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Looks like you edited your message before I had a chance to respond. To change radio modes on the AEBS, you would use the AirPort Utility. (ref: AirPort Utility > Manual Setup > AirPort > Wireless tab > Radio Mode)

  14. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I changed it 102.11g only and to 102.11b only and I get the same result. DNS error.

    I also hard wired the cable into the PS3 and it had all the same information that I had been typing in through the router (except for the router number).

  15. 0

    PetFed311

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Is there any firmware updates for my router that would help?