Benches Networking

2

problem configuring 4 AX's and 1 TC

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

this should really not be this hard. considering the rep apple has for ui, the airport admin app needs some attention.

anyway, i have what i consider to be a simple setup. i have a large wired network. it involves my house, separate garage, and barn. there is copper running between all the buildings.

my issue is currently restricted to my house. i have a TC, which hosts my internet connection and two additional AX (older B/G units). my TC is at one extreme end of the house, one AX (call it Middle) is in the middle of the house, and one AX (call it Bedroom) is at the other end of the house. they are all connected to the same switch.

the TC runs the DHCP network, and everything seems to be OK with it.

the distance between the units is about 40' from TC to Middle, and an additional 40' to Bedroom. how do i configure these so that i have one House Network, and the right thing happpens? do i need to use WDS? i dont think so, since they are hard wired together. do i have the AX's "join" the House Network that the TC is configured to create?

currently, the AX's "joined" the existing TC created network, but i think that the AX's are fighting since my icon on the iBook usually shows 1 (or 0) bars, but i am sitting 10' from the AX called Bedroom. in this configuration i believe everyone is using channel 1, but the AX's dont seem to have an option to force them to another channel while they are "joined".

the AX's are all running 6.3, the TC is running 7.4.2, which i believe is the current release for both.

and,since it will come up, what about the other two AX's? Garage is close enough to the house that you can see the house network from it, the signal is just week. Barn is too far off to see anything else (although they are all wired to the same switched ethernet network.

2 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Since they are connected by Ethernet, you do not use WDS and you do not use "join" an existing network.

    Instead you configure both AX to create a wireless network with the same SSID (network name) and wireless encryption type/level/password as that used by the Time Capsule.

    You also would configure the middle AX to use a channel as far from the one used by the Time Capsule as possible. You can configure the Bedroom AX to use the same channel as the Time Capsule since it is so far away from the Time Capsule.

    Also you would configure each AX to act as a bridge (not sharing a single IP address). This disables their DHCP/NAT services. Any clients connecting to an AX will get an IP address from the Time Capsule. This results in seamless roaming between the base stations and ensures that all clients are on the same subnet.

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    there we go. thanx.