Imported from the Apple Support Forums via the Wayback Machine 🔗
I have vpn server at home set up under OS X Server, both PPTP and L2TP. They all work fine. I am trying to figure out how to route traffic over the VPN for internet browsing. In the VPN server setup I have my internal DNS listed and it has a forwarder set up in the DNS configuration. In search domains I have mydomain.com. In the Network Routing Definition I have my network setup 172.16.1.0, subnet 255.255.255.0, private. I also have 0.0.0.0, 0.0.0.0, public. When a client connects all they get is the page cannot be displayed. I can browse sites in mydomain.com or in my DNS. I tried an external DNS in the DNS settings and adding a * in the search domains with no luck. The clients are set to send all traffic over the vpn. I know about the reasons not to do this but I am testing something right now. Any ideas?
Imported from the Apple Support Forums via the Wayback Machine 🔗
"Network Routing Definition I have my network setup 172.16.1.0, subnet 255.255.255.0, private. I also have 0.0.0.0, 0.0.0.0, public."
For a default route through the VPN either leave the routing definitions empty or use : 0.0.0.0, 0.0.0.0, private.
Then you need ipforwarding ON in the server. iforwarding is ON if firewall is running but otherwise you need to turn it on yourself. In Tiger server you could use NAT config in SA to turn just ipforwarding (NO NAT) on. It might still be there (haven't looked).
It's also possible to turn it directly on by doing: sudo sysctl -w net.inet.ip.forwarding=1
For this to survive a reboot eiher put net.inet.ip.forwarding=1 in a readable file /etc/sysctl.conf
or edit /etc/hostconfig to have this line: ipforwarding=-YES- (What SA NAT "just ipforwarding" does).
And it is really "subnet mask".
0
Barry Keel·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Ok I'll give that a try. I do have the firewall off on the server as it is behind an airport extreme. I did not think that I would have to do that with the AE doing the NAT, correct?
0
Barry Keel·
Imported from the Apple Support Forums via the Wayback Machine 🔗
I added NAT and selected IP Forwarding Only and it now works fine, with the exception of Windows clients. They have the issue of not surfing at all. Error that says the page cannot be displayed. Doesn't matter in they route all traffic over the vpn or not. Any ideas?
0
Leif Carlsson·
Imported from the Apple Support Forums via the Wayback Machine 🔗
When connected to VPN on Windows do:
route print
in a command (DOS) window then post results here.
Remote network (from where VPN clients connect) and server LAN cannot use the same subnet/network number.
Stay away from using 192.168.0.0/24 and 192.168.1.0/24 on server LAN.
Can you ping using names in a Windows command window?
0
Barry Keel·
Imported from the Apple Support Forums via the Wayback Machine 🔗
No I cannot ping anything on my network where the vpn server is located. When I ping I get my public ip. I cannot even ping the server by ip. I cannot browse to any websites EXCEPT the ones on the network with the vpn server. Weird?
BTW, the 172.16.1.206 is the ip of my machine on the vpn. Do you think it may be the Windows client configuration.
Imported from the Apple Support Forums via the Wayback Machine 🔗
Not really. One thing I do notice when doing an ipconfig on the Windows box is that the gateway for the Windows box is its on vpn ip. Should this be that way?