Imported from the Apple Support Forums via the Wayback Machine 🔗
- duplicate - my bad...
0
K T·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Have you looked at the Console error logs for any additional information?
Go to System Profiler/Logs...
0
iphonemrdev·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Well, I am at the office and the built in client decided to work. I will try again when I am home - not sure what the difference is... I may have done an update between then and now.
0
iphonemrdev·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Yep, everything works fine now. Must have been the 10.6 -> 10.6.2 update.
0
smattoon·
Imported from the Apple Support Forums via the Wayback Machine 🔗
I'm experiencing the same error on 10.6.2. system.log says ...
Nov 29 13:26:43 Scotts-MacBook-Pro-2 configd[14]: IPSec Controller: cannot connect racoon control socket (errno = 61)
Nov 29 13:26:43 Scotts-MacBook-Pro-2 configd[14]: IPSec Controller: cannot create racoon control socket
Nov 29 13:26:43 Scotts-MacBook-Pro-2 configd[14]: IPSec Controller: restart failed
Nov 29 13:26:43 Scotts-MacBook-Pro-2 configd[14]: SCNCController: Disconnecting. (Connection tried to negotiate for, 0 seconds).
Any ideas?
0
p3ter·
Imported from the Apple Support Forums via the Wayback Machine 🔗
hi guys
i have the same problem....
has anyone figured out a solution?
thanks!
0
BoyHowdyDoo·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Make sure you have 4.9.01.0180 build.
Try running ifconfig -a. See what may be running w/o your knowledge.
Sometimes ports get held up by Cisco. If you find a rogue port just use this command.
sudo ifconfig en0 down
en0 could also be whatever the port is you want to end. fw0, en1 etc...
Also this has always fixed things for me in the past: