Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi all, I have a problem I hope someone can help me with. I accidently upgraded my G3 333mhz powerbook 500 mb ram to newest quicktime version which should run on a 400mhz machine. To try and fix the problem I took off quicktime and tried installing an older version. This failed so then I said screw it I'll just remount the harddrive and reinstall OSX Panther. Tried doing this but during the install my computer totally bugged out. The screen just started flashing and stuff. So I was like hmm let's see if it takes the old OS9 factory installs fine. So anybody have any idea why the OS9 install works yet I can't install OS 10 Panther on it again. Note, it had Panther on it for 3 yrs prior to this. Any help would be greatly appreciated.
Imported from the Apple Support Forums via the Wayback Machine 🔗
osmiumtet,
The Lombard (and Wallstreet) can be quite sensitive to RAM when installing OSX. A few of these 'books have a problem like yours when trying to run the OSX installer with more than 256MB of installed RAM, yet 9.x works just peachy. Once OSX is installed and restarted to X to finish up, it works fine again with the additional RAM.
I would suggest two things:
-First, reset the PRAM from a cold start as you are booting to the OSX CD, then see if the installer runs normally.
-If no success, remove the top 256MB module, then try running the OSX installer. If successful, you can then reinstall the RAM.
Message was edited by: jpl
0
Apple Support Community member·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi all. I reset the PRAM as suggested and the installation went as smooth as silk. Thanks for the help.