Benches macOS

5

Cisco switch configuration for Netboot

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

I remember reading something a while back about having to "enable" or "disable" something on the ports of a Cisco switch in order for Netboot to work. The clients could not establish an IP address quickly enough or something like that...

does anyone know about this?

thanks.

---

eric

5 replies

Sign in or join Beachball Help to reply.

  1. 0

    varjak paw

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Here's what an Apple engineer told me:

    PortFast on, Speed and Duplex Auto, Trunking off, PaGP off

    I haven't tested it on our Cisco switches so I can't say he's correct. Hope it helps, though. Please let me know if it does or doesn't, as we have a similar issue with NetBoot through our Ciscos.

    Cheers.

  2. 0

    Eric Tsai

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    I think that was it. enabling portfast it worked for cisco 2900 series switches we had configured 2 years ago running netboot/netinstall with a G5 10.3 server and panther clients. but the school installed new switches and since then the netboots/netinstalls have not been working. i assume once we get portfast enabled again things will go smoothly...

    thanks.

    ---

    eric

  3. 0

    varjak paw

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    If you would, please post back and let me know for sure once you try it. That way I'll have solid information when I go to our own network admins.

    Cheers.

  4. 0

    Mark Helman

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Yes, please post back as I am interested in the results as well.

    Thanks,

    Mark

  5. 0

    C.Moser

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Please tell me the result... i'm having speed problems!

    Xserve is connected to Switch 3950 GB and then through 2950 with GB. The clients have 100Mbp ports.

    When i try to start netinstall the average speed on the server is around 5MB/s or less... it takes ages to clone a mac (the image is around 16GB).

    If i try directly on a GB port it takes around 40min and the average speed on the server is around 12Mb sec....