Benches MacBooks

6

MacBook Pro screen does not turn off when…

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

When I close the lid of my MBP the backlight for the display does not turn off. I am assuming that it is not sleeping.

I use the MBP in clamshell mode with an external monitor at the office but the no sleep on close issue happens pretty much all the time.

Is this normal? Is there some setting I can change to get sleep on close?

6 replies

Sign in or join Beachball Help to reply.

  1. 0

    louie

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Perhaps the activation magnet in the screen has slipped. You can test by getting any magnet, and holding it on the far right edge of the MBP, about 3.5 inches from the front (just below the speaker grille).

  2. 0

    S.U.

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    You can always go to energy Saver and be sure nothing is set to "Never Sleep."

    You could also try resetting the SMC, since this does control some sleep functions:

    http://support.apple.com/kb/HT1411?viewlocale=en_US

    On my MBP, the sleep magnet is on the right side of the display slightly over half way up--you should be able to find it with a paperclip. If it's not there, then that's likely the problem and you will have to tell it to sleep manually.

    Good luck!

  3. 0

    Thomas Seery

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Louie -

    I have the mid 2009 MBP - is there a magnet inside the unibody aluminum housing? The lid latch below the track pad is smooth and seems to have some magnetic attraction to the lid itself.

    S.U. -

    My problem is that the screen does not go off when the lid is closed. The problems described with the SMC reset involve the screen backlight not turning on. It also says to not reset the SMC unnecessarily. WIll that reset affect anything else?

    Tried the paper clip - no joy. Will check with a magnet at work.

    Is there a time setting for sleep mode on close?

    Message was edited by: Thomas Seery

  4. 0

    louie

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Aha. You're posing in the wrong forum. You need

    http://discussions.apple.com/category.jspa?categoryID=251

    for the late 2008/2009 unibody MBP. This is for the original aluminum MBP.

  5. 0

    Thomas Seery

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Thanks. It may simply be that with the 4GB of RAM that I am not being patient enough when I am paying attention.

    I saw some things about this in the forum you referred me to.

    Thanks for your help.

  6. 0

    S.U.

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Sleep is caused by a magnet activating something like a reed switch. If the magnet is missing or displaced, then the reed switch which puts the Mac to sleep will never be activated and the Mac won't sleep.

    Do you have access to a store that retails Macs similar to yours? If so, see if you can find the sleep magnet on one of them. If you can, but cannot on yours, then that is the problem, and it will be covered by your warranty.

    Good luck!