Benches MacBooks

2

Macbook sound balance/phase issue when he…

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

Hi All,

I am experiencing a strange issue with the sound balance on my Macbook.

When I use the built in speakers the sound is fine.

When I use speakers via an external amplifier (through the 3.5mm jack) the sound is fine.

When using the built in speakers, or external amp, setting the balance to "L" puts
all sound to the L and all sound to R when set to "R" (as expected)

When I use headphones, the sound balance is all messed up. The main indicator is that vocals go missing and when you put the balance to L there is sound out of both channels (although the L is slightly louder). The effect is the same when balance is set to R (the R is slightly louder, but sound from both headphones). The missing vocals happens in all programs (iTunes / Cog / VLC / youtube)

I have tested using 3 sets of headphones (2 apple headphones and one Sennheiser). Each of these headphones works fine when plugged into an ipod or other device.

I don't understand how this can be. I have confirmed the balance setting is correct for each "mode" of use. Does the macbook have a different setup for headphones as opposed to external amplifier?

I am very confused. Any thoughts??

Thanks,

Ben

2 replies

Sign in or join Beachball Help to reply.

  1. 0

    Pancenter

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Since you haven't received a response I'll throw out a couple of ideas.

    I've heard the same type of thing when headphones have gone bad and grounded a hot wire on one side, obviously not the problem with your setup. It's possible the software involved is sensing the headphone impedance and changing output to something other than stereo.

    Things to check:

    -If you're listening using iTunes, under Preferences/Playback, make sure "Sound Enhancer" is unchecked.

    -In the Utilities folder, open Audio/MIDI setup, check the Configure Speakers button and make sure the multichannel setup is set to stereo, and set to left-1, right-2, do this with the phones plugged in.

    WARNING- avoid clicking on the "left front/right front" buttons unless the sound is turned way down, you will get a blast of white noise.

    -Instead of inserting the jack all the way insert it partially while playing one side only, when that side comes on move the balance slider to the other side and see if you're getting sound. (doubtful, no real reason it should work this way.)

    The jack for the external speaker and the jack for the headphones are identical, correct?

    pancenter-

  2. 0

    fearofpudding

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Thanks for the reply pancenter.

    I have checked the sound enhancer, it is unchecked.

    The multi-channel setup is as expected (stereo for multichannel) - I thought this might be the problem but didn't know where to check it - now I know 🙂

    I tried partially plugging in the cable, but it only seems to enable output once it is firmly plugged in.

    Yes, the jack of the external speakers and the headphones are identical (both are 2 ring + tip 3.5mm)

    ..the problem continues...

    ~Ben

    Message was edited by: fearofpudding