Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi all, I’ve been migrating an old iMac 10.6.8 to a brand new iMac using migrate assistant. Everything worked fine. I was told 1hr 30m until 32 min where it has not progressed past 32 minutes.
Now I know there can be issues. However, it’s still stuck at 32 minutes but the transfer speed still fluctuates between 24 to 25 MB/s using the network. Does this mean it is still working away? The location where it has stalled is the largest chunk of data to transfer.
Imported from the Apple Support Forums via the Wayback Machine 🔗
You're welcome.
Yes, there's no way software for a PowerPC was going to work.
0
rkaufmann87·
Imported from the Apple Support Forums via the Wayback Machine 🔗
You can check with the developers to see if they ever updated their software to run on Intel Macs?
0
dialabrain·
Imported from the Apple Support Forums via the Wayback Machine 🔗
I would wait it out for a bit.
0
Danpetrevie·
Imported from the Apple Support Forums via the Wayback Machine 🔗
And I did just that and it worked. Thank you for responding. It’s the works Mac and I was trying to get it ready for work tomorrow.
Unfortunately since the old Mac is a PowerPC our very expensive litho software (Kodak Preps) won’t work.
Arghhh
0
dialabrain·
Imported from the Apple Support Forums via the Wayback Machine 🔗
You're welcome.
Yes, there's no way software for a PowerPC was going to work.
0
rkaufmann87·
Imported from the Apple Support Forums via the Wayback Machine 🔗
You can check with the developers to see if they ever updated their software to run on Intel Macs?
0
Danpetrevie·
Imported from the Apple Support Forums via the Wayback Machine 🔗
unfortunately they do but you have to pay for the new version. They’ve got me by the short and curlys I’m afraid. I take it there’s no way to run snow leopard on a Parallel?
0
rkaufmann87·
Imported from the Apple Support Forums via the Wayback Machine 🔗
You can try however I'd just pony up and get your software current. However then again, it's your money that I'm "spending", as far as Parallels running 10.6.8, you can try if you want?