iMac G5 Hard Drive Upgrade--Jumper settin…
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi. This is a pretty technical question, and Apple tech support could not answer my question over the phone. I'm hoping someone on this forum can help out.
My iMac G5 20" 1.8 GHz was mfd. in Jan. 2005. It has a 160 GB SATA drive from Seagate (via Apple). This is a model 7200.7 Barracuda. It has jumpers on two pins, but I don't know why. On the Seagate (non-Apple) 150 GBps drives, Seagate says that no jumpers are necessary, so I don't quite understand this.. but that's not my question.
The logic board has been replaced, which presumably also replaced the SATA controller.
I am replacing the drive with a Seagate 7200.11 Barracuda 320 GB drive, which is capable of 300 GBps interface. According to the Seagate web site, I need to install a jumper on this new drive *only if* the SATA controller on my iMac G5 is incapable of handling the 300 GBps interface.
Does anyone know if this speed-limiting jumper setting is required for my iMac using a 300 GBps SATA drive?
Thank you.
5 replies
Sign in or join Beachball Help to reply.
- 0
- 0
- 0
- 0
- 0