Benches Mac desktops

5

iMac G3 shuts down randomly. Help

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

I just got a used iMac G3 with OS X on it. I am new with mac's but I know my way around them. But when I was trying it out today it just shut down randomly. And I don't know what the cause of it was for. It gave me no warring. It has happened three times so far with throught out the whole day. Can anyone help?

Thanks Tyler

5 replies

Sign in or join Beachball Help to reply.

  1. 0

    Kenichi Watanabe

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    This can start to happen is the PAV board is starting to fail. This is the component that provides the power and high voltage needed to drive the CRT. Over time, the problem may get worse, until it happens more often and eventually will not start up. It is a common failure point for the CRT-based iMac, although if it's 700 MHz, while it is still
    old, it is the newest of iMacs with a CRT display, so perhaps less likely.

    It is also possible that it is overheating. If it's 700 MHz, it is cooled using heat convection (there is no fan), so be sure to leave a unblocked path for air circulation between the bottom vents and the top vents. Look inside to see if there is any excessive dust accumulation.

    Also, make sure that the iMac is NOT plugged into a power strip (if you use one) that getting too old or too overcrowded with other connected devices. Try connecting it directly to a wall outlet as a test, to see if there is any difference. When you reconnect it, do not connect any peripheral devices (especially USB) except for your standard keyboard/mouse (try a different keyboard and mouse if you have another set).

  2. 0

    Rocknail

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Is there any way to replace toe PAV board? I have another scrap iMac laying around can I take the part out and inter change it?

    And thanks for replying, you answered my main

    question.

  3. 0

    Kenichi Watanabe

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Well, it may not be the PAV board, if it continues to start up and run at least for a limited time. If it gets progressively worse over time, until it does not start up at all, then there a very good chance it's the PAV board.

    There are other folks here who have more hands on experience taking the slot-loaders apart than I do (I know more about the older tray-loaders iMac G3 machines). Hopefully they will pop by with answers about swapping the parts. It would be helpful if you specify the two iMac models; you can see a list of the models here

    http://www.everymac.com/systems/apple/imac/index-imac.html

    I added an additional point in my last post, in case you missed it. Something you can try to test the problem.

  4. 0

    Rocknail

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Ok I will try that. The first time it shut off I pushed the power button and the screen was all blurry and had a bunch of lines on the screen, is because of the PAV board. I guess I should have put that in my first post, sorry about that. And thanks again This should help me out alot.

  5. 0

    Jeff

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Be aware that replacement of the PAV board requires discharge of the CRT, to eliminate the possibility of dangerous/lethal electrical shock. You may want to have someone with CRT-TV repair experience perform the swap, assuming that your other iMac is a similar model with the same board.