Kenichi Watanabe wrote:
If you still have that 400 hub and only 400 devices, you can connect it to the 800 port through an adapter (or a cable with the right connectors). If you have one newer 800 device and the rest are 400, connect the 800 device directly and connect the hub off the daisy-chain port. Then connect the other devices to the hub.
Ya there lies the problem, well more of an annoyance than a problem. I have a FW800 drive, so that is plugged in directly to the back of the iMac. I then can daisy chain other FW400 drives off the back of that drive. But it still requires that drive by turned on to get to anything I daisy chain off of it. That FW800 drive has a fan so it is kind of loud so I rather only have it on when I am specifically using the drive.
If the iMacs had TWO FW800 ports then I could plug the FW800 drive into one and my Belkin FW400 hub into the other and then all the FW400 drives into that. Then all drives could be independently powered and will be seen on the Mac.
Hopefully, that will be sufficient until some other third parties create 800 hubs and bring the price down a bit.
Ya, so far I have found two possible hubs but at $$$. One is a three-port FW800 hub for $50 which would give me my two FW800 ports as mentioned above. The other was a nice looking 6-port FW800 hub giving me 5 FW ports to plug drives into that could be powered up and mounted individually. However that one was $100!!!
For the three port one, it almost seems better to find a FW800 enclosure with three FW ports on it (typically two FW800 and one FW400) and don't put a drive into it and use it only as a hub (but have the option of popping in a drive). However I haven't run across one that is cheaper than the 3-port hub yet. But if I get a fanless one, then I can run a drive in it and use it as a mini-hub and not have to hear a fan running when using it mainly as a FW repeater and not actively using the drive in it.
The search continues!
Patrick