Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi All,
I finally have got round to replacing my internal Maxtor 250HD that had packed up with a Western Digital SE16 300GB.
I followed the Apple documentation for the DIY HD replacement on a iMac G5.
However during the process I had trouble disconnecting the HD Temp Sensor cable. The documentation makes it appear the part should unclip; I tried carefully to apply pressure and lever from various directions, non of which seemed to work. After trying these various methods the connector seemed to crumble and the 4 individual wires came out seperately.
I continued and removed the defunct HD and replaced with the new. I wrapped each end of the 4 wires with insulation tape and left them free.
Obviously I no longer get a temperature reading; is this important? I guess knowing the internal temp can avoid problems, but will it affect the way the iMac operates?
Imported from the Apple Support Forums via the Wayback Machine 🔗
Hi all
Just to update this post:
I have successfully replaced the HD Sensor Cable with a new one. It was a right fiddle to remove the old one as one end was still connected to the main board of the iMac. But with some careful leverage from underneath and pulling the wires (I know it says not to but the part was destroyed anyway!) I got it out.
I replaced the HD back into position, but not bolted down, and then connected the Thermal Sensor Cable firstly the HD and then the Main Board, once that was done I bolted the HD down and replaced the part of the fan ducting to the right of the HD which I had to removed.