Benches Mac desktops

7

blueberry dead - really dead - extract HD?

apple Verified

Imported from the Apple Support Forums via the Wayback Machine 🔗

HI -

Well, my "will not boot" problem on my blueberry iMac appears to be something more than the battery. THanks to people on this site, I was able to replace the little battery with some hope - but to no avail. Mac Genius was ready to send it in; said it's either power train or logic board...same thing people here said...$400 minimum. Makes no sense; buy an imini for close to that.

Anyway, I need to retrieve the hard drive - can someone give me a link to instructions about how to do that? Not sure what kind of connector is on those drives, and whether my IDE-to-USB adapter will work?

That leaves me with basically the CRT and a bunch of pretty useless stuff. But the CRT must be useful in some way - is there a graveyard for old mac scrap?

THanks,

Mike

7 replies

Sign in or join Beachball Help to reply.

  1. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Michael, all G3 iMacs use a conventional IDE HD, so your adapter would work, you will of course need to change the jumper settings, depending how you aim to connect to this HD, USB seems to prefer "slave", whereas firewire likes "cable select". To remove the HD, you need to take the iMac to bits as with replacing the battery, you will see a metal cage between the two speakers, this holds the HD and CD-R drive. To get the HD out, you do not need to remove the cage, just locate the screws (4 of them) that fix the HD in place. Undo these and the cables and the drive should push out backwards. On some iMacs, the HD is covered in a plastic coat that makes it a tight fit, so firm, but steady pressure may be needed.
    best wishes
    Andrew Platt

  2. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    THanks a lot Andrew. Any suggestions about what I should do with the CRT and/or other parts? Even seems a shame to put the pretty case out on the curb. Maybe it'll make a nice flower pot.

  3. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    hmmmm...Andrew, where on the drive are the jumper settings set? I can't see any switches; the maxtor drive is labeled "non-slave" on the front and I don't see the usual set of four switches...

    when I try to boot up with the drive attached, I hear it clicking away but the login stalls at "waiting for local disks." I presume this is because it isn't slaved.

  4. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Never mind...the 'local disk' eventually responded and I was able to get all of the data back.

    I'll post the questions about the residual items in another post.

    THanks again!

  5. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Michael, if you have the time, try ebay, offer the iMac for spare parts, buyer to collect. Its not worth much
    best wishes
    Andrew

  6. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    Michael, on most Maxtors, they are between the cable pins and the power port, I suspect that if you take out the jumper, that will work. Remember that your USB to IDE adapter is going to be slow, probably 1/10 of IDE speeds
    best wishes
    Andrew

  7. 0

    Apple Support Community member

    Imported from the Apple Support Forums via the Wayback Machine 🔗

    How about using as a shell for a fish tank?