Imported from the Apple Support Forums via the Wayback Machine 🔗
Looking for advice re probably cause of a language screen freeze in a 30gb 5th gen iPod video. Have tried taking unit fully apart to inspect, no evidence of a cable break in the click wheel, cleaned area around wheel, re-seated hard drive and battery. Battery charges fine. Unit is detected in iTunes Windows version and can be restored by iTunes, but on restart, comes back to the language screen and freezes (no click wheel response or center button response). I found a replacement hard drive to try for cheap, but I am wondering if the above issue is most likely a) hard drive issue, b) a main board issue, c) click wheel issue? This unit is mostly nostalgic for me, lack of bluetooth limits its usefulness for me, but I wanted to get it working again if I can do for a small investment. Thanks for any community wisdom on this.
Imported from the Apple Support Forums via the Wayback Machine 🔗
I'll see if I can get it to show me stats...it was frozen at the language screen and would not reboot or restart from that point. Is there a way to make it go into diagnostic mode when the iTunes software resets it?
0
turingtest2·
Imported from the Apple Support Forums via the Wayback Machine 🔗
No, diagnostics mode is only available using the scrollwheel combinations as the device is booting up.
tt2
0
J English Smith·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Well, Turing, with new hard drive in place, no change. It will let me reset it, it is charging, and iTunes seems to successfully synch some songs (tried in both Windows and Mac software; same result). But no matter what I do, when the iPod is ejected from iTunes, the unit remains frozen at the language set screen with no action possible from the clickwheel or buttons. After a while the screen dims. Toggling the hold switch off and on will bring the language screen back up and with backlight. Seems from my testing that the HD is NOT the problem. Is what I'm describing a borked main board or rather the trackpad assembly/cable?
0
turingtest2·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Is what I'm describing a borked main board or rather the trackpad assembly/cable?
It would seem so.
tt2
0
J English Smith·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Any definite advice re which? I can get a working trackpad assembly for under $10, but a mainboard would cost quite a bit more.
0
turingtest2·
Imported from the Apple Support Forums via the Wayback Machine 🔗
I don't know how to tell for certain, but if it runs at all the main board is probably OK. My own experience with classics runs to swapping out batteries and the headphone jack/hold switch assembly.
tt2
0
J English Smith·
Imported from the Apple Support Forums via the Wayback Machine 🔗
Thanks! I may try pulling the trackpad cable and re-seating, and if that doesn't work, just selling it and the cases off for parts. My shuffles are actually more useful to me now as I like to use them rather than my (Blackberry) phone when I'm working out. I'm sentimental about older tech but the lack of BT or a speaker makes it hard for me to justify saving this one... Thanks for the help and comments, Turing!
0
turingtest2·
Imported from the Apple Support Forums via the Wayback Machine 🔗