Disk Utility will not format/erase/partition an...
Imported from the Apple Support Forums via the Wayback Machine 🔗
Well, I'm back with a RAID problem again. This time the powers that be sent me a Sun Microsystems StorEDGE A5200 RAID box (22 33gig disks). It's a fibre channel system, and is full of Seagate FC disks. The box only hooks up to my G5 Quad via the Apple Fibre channel card that I have hooked up. It's a dual channel card and both are plugged into the back of the RAID array.
Now, here's what I have.....
The Drives show up in both Disk Utility and Anubis
The is only one drive formatted and it works fine.
All the rest of the drives are unformatted (not just blank, but without any operating system on them, just like they were fresh out of the box)
Attempting to Erase a disk results in the message
Disk erase failed
Disk erase failed with the error:
Invalid Argument
Attempting to Partition a disk results in the message
Partition failed with the error:
Invalid Argument
Attempting to create a RAID set results in the message
Creating RAID set failed with the error:
Could not add a RAID disk to a RAID. (note there was no other RAID set)
Only one disk in the array is formatted and it will respond to all of the functions in Disk Utility.
I was told that I needed to do something using the command line, but that was pretty vague as to what I needed to do. Apparently I need some sort of superuser authority to get these drives formatted, and that's it's not documented any where.
So folks, I leave it up to you again, what do I do?
1 reply
Sign in or join Beachball Help to reply.
- 0